System Deposition for Hollow Membrane Compact Model

Micrometric Manual Film Applicators
Micrometric Manual Film Applicators
May 19, 2016
System Deposition for Hollow Membrane Full Model
System Deposition for Hollow Membrane Full Model
June 13, 2016
Show all

System Deposition for Hollow Membrane Compact Model

System production for hollow membrane. The compact model includes only the polymeric solution delivery system, as described in the next table.

The following product could be designed according to the client requirements
Datasheet

Storage Tank:
Stainless Steel AISI 304 storage tank: double chamber with load capacity around 1 liter, two GAS coupling of ¼” for inlet and output of cooling and heating liquid (from -20°C to 150°C) with a maximum pressure of 10bar, GAS coupling of ¼” for exhaust product. Flange for steel AISI 316 storage tank with a 3/8” GAS inlet in the middle including tap, two holes of ¼” GAS for lodging manometers, seal lodging, O-ring made f FETFE and/or Silicon/Viton;

Basic Installation stainless steel AISI 316L:

  • Analog Pressure Gauge: AISI 316 steel made for tank
  • Analog Pressure Gauge: AISI 316 steel made for branch output of the gear pump
  • AISI 304/316 steel holder for storage tank
  • AISI 304/316 steel holder for tank/engine/pump
  • All-steel AISI 316 pipe line with diameter of ø 6mm
  • Ball valves made of AISI 316 steel
  • Reducer and Speed Regulator for reducer, power supply 220Vac

Gear Pumps: n.1 Mod. 0,2 cc/rev – Tmax 80°C

This product can be designed to reach and keep up to 300°C on all Polymeric Solution Delivery parts with Electric Heater and PID Controller for Temperature Regulation. Ask for Quotation, or see System Production for Hollow Membrane Full Model.

Catalog Info: SYS-DEP-HM-CM

Contact Us

[contact-form-7 404 "Not Found"]